Installation manual

Windsor Installation Manual - Issue C
-
38
-
Internal Serial Bus
SmartDial
SmartDial is a combined dialler/modem which connects to Windsor on the internal serial bus.
SmartDial is fully programmable from a Windsor keypad and can share a telephone line with
a telephone handset(s). Refer to the SmartDial instructions for the telephone line connections
and features. The PCB layout shown is for a SmartDial/SmartDial Plus but the terminals are
in the same position in a SmartDial Super.
Telephone line
Connections
Status LEDs
Main PCB connector
Control Panel link
(Fit link for use with a 500)
SmartDial Super
Approvals
Country Approval Number
Belgium TBA
UK 503921
Eire DOC 108/96
France TBA
Italy TBA
Netherlands 961485
SmartDial
LED Status Indicators
SmartDial Super has 3 status LEDs. There are no status LEDs on SmartDial/SmartDial Plus.
Function Green
Line Stat
Red
Hook
Orange
Call Prog
Exchange Line Voltage OK On
Insufficient Exchange Line Voltage Off
On line (off hook) On
Off line (on hook) Off
Line activity On Flash
Idle status (every 6 secs) Off Flash
Ringing detected (version 2.07 or later only) Flash Flash
SmartDial reset (version 2.07 or later only) Alternate
flash
Alternate
flash
Data transmit(version 2.07 or later only) On Flash