Installation manual

Windsor 500 Installation Manual - Issue C

Inova Hardware

Wiring Details

Refer to wiring diagram (Main Circuit Board) on Inova Installation instructions.

1. On the main terminal block, terminals 1-4 should be connected to the control panel

user interface bus (CON 9 ).

Terminal 1 +12V

Terminal 2 Clock

Terminal 3 Data

Terminal 4 0 v

2. Refer to detail B, Inova Installation Instructions (Door Strike Wiring). The power

supply should be taken from one of the auxiliary power outputs on the Windsor main

board (CON 21), or alternatively a separate PSU.

Inova Hardware

Relay Connections

The alarm relay mimics the door contact at all times. Alarm and tamper can be wired to a

convenient circuit on an internal or external concentrator. For BS4737 Installations, the circuit

should be identified as an entry exit type (EnEx) for final door setting. If however, the Inova is

outside the protected area, the circuit should be identified as a NA alarm type.

Inova Cardpoint

Programming

The Inova Cardpoint unit is capable of interfacing with the Windsor Control Panel, enabling the

user to set or unset the alarm system (similar to a normal keypoint), in addition to normal

access control functions. Note, however, that the use of bank cards is precluded. All

programming events are verified via red/green LED indicators.

Inova Programming

Adding / Deleting Alarm Users

Specified users can be given authority to set or unset the alarm system. When you program

an alarm card user Windsor will set the authority automatically to “Inova” which allows only set

and unset. This authority can not be changed using a Windsor keypad or GuardStation.

Function Command Command Parameters

Add a new user #31# aaaaa #ii# aaaaa = the card number

ii = the user number ( 3 to 40 ).

Delete a user #33# aaaaa#. aaaaa = the card number

If a new alarm card is assigned to an existing user number then the old user will be deleted

automatically. It is not possible to add or delete an alarm card user if any area of the alarm

system is set, or if the engineer is logged on.

Alarm Panel Interface Functions

Specified users will be able to set and unset the alarm panel. While the alarm system is set,

access can be denied to all card holders until the panel is unset, or access can be permitted

only to those users with authority to unset the alarm panel. The alarm LED's on the Inova unit

(mains, ready, day and message) have the same meaning as those on a Windsor Keypoint.