Installation manual

Windsor 500 Installation Manual - Issue C

User Interfaces

Inova Cardpoint

The INOVA Cardpoint has set and unset buttons and 4 status LEDs as standard. All

Cardpoints are connected to Windsor on 4 wire UI bus. The Cardpoint can be used as a

normal access control unit and to set and unset Windsor.

The normal guidelines for installing a standard Inova Access Controller should be followed.

This section details additional connections and programming required to interface the Access

Control Unit with the Alarm panel.

Windsor Status LEDs

Unset Button Set Button

Inova Cardpoint

Hardware

Inova Hardware

Addressing

All Cardpoints are identified by a unique address which is set using links on the Cardpoint

PCB. The Cardpoint addresses must be in sequence from 1 up to the maximum number

specified in the System Size programming option.

UI LK4 LK3 LK2 LK1

0 / / / /

1 X X X X

2 X X X /

3 X X / X

4 X X / /

5 X / X X

6 X / X /

7 X / / X

8 X / / /

/ Link Fitted

X Link not fitted