Installation manual

Windsor 500 Installation Manual - Issue C
-
22
-
User Interfaces
Keypoint
The Windsor keypoint has backlit set and unset buttons, 4 status LEDs and an electronic key
socket as standard. All keypoints are connected to Windsor on 4 wire UI bus.
Status LEDs
Set and Unset backlit
buttons
Electronic key socket
Keypoint
Installation
The keypoint should be fixed to the wall through using the fixing holes provided. If the off the
wall tamper is being used then the tamper knockout should be removed prior to mounting the
rear case.
Case fixing points
Off the wall tamper
Trunking points
Conduit point