Manualshelf

User guide

ManualsBrandsBT ManualsComputer equipmentMobile Broadband Laptop
12345678910
Quick reference guide 7
6 Connect computer
Choose whether to connect your computer to your Hub using the CD or without the CD.
Connect computer using CD (recommended)
Run the CD to help you connect your computer to your Hub and make sure your computer is set up correctly for using BT Business Total
Broadband. If you have more than one computer, run the CD on each one to connect it to your Hub.
1 Insert the CD into the computer that you want to connect to your Hub.
2 Wait a few moments for the CD to start, then follow the on-screen instructions.
If the CD asks you to enter your username and password, see your ‘welcome’ email and letter or, if you can’t nd these,
www.bt.com/business/help
Connect computer using wireless without the CD
1 If your computer is already connected to your Hub using an Ethernet cable, unplug this cable.
2 Place your computer close to the Hub for a good wireless signal.
3 If you haven’t already, install your wireless adapter in your computer using the adapter manufacturer’s instructions. If you’re using a laptop
with built-in wireless, turn wireless on by using the wireless switch (if your computer has one) or activating wireless from within your wireless
software. Your wireless adapter must be 802.11b or g compatible.
4 Find your Hub’s preset wireless network name/SSID and Wi-Fi key (WPA2). These are printed on your wireless settings card (found in your BT
Business Hub’s box) and also on the side of your Hub.
Your wireless settings card Wireless settings label (on side of Hub)
BTBusinessHub-XX
XXXXXXXXXX
XXXXXXXXXXXX