Owner`s manual

EMPIREPAINTBALL.COM
5
4. Set the marker to “Fire” mode (Turn Electronic Grip on or turn safety off).
5. Pull the trigger and check the reading on the chronograph.
6. Locate the velocity adjuster screw
on the left side of the marker.
7. Using a 5/32" hex key, turn the
screw inward or clockwise to
reduce the velocity, and outward
or counterclockwise to increase the
velocity of the paintballs discharged
from the marker.
DO NOT REMOVE THE VELOCITY
ADJUSTMENT SCREW.
6. Electronic Grip Operation (some models)
The Electronic Grip has 3 different firing modes: Semi-Auto, Ramping, and Full-Auto.
The modes are changed by removing the left-side grip and adjusting the dip switches
located in the grip frame.
The Electronic Grip comes in Ramping mode from the factory and the Jumper in the
frame must be removed to lock the firing mode to semi-auto. The Electronic Grip has
an automatic shut-off after 1 hour of inactivity.
Activating the Electronic Grip™
To activate the electronic grip, press the On/Off
button on the back of the frame. A green LED
will come on to show that the electronic grip is
activated and ready to fire.
Note: Always use name brand batteries. Using
other types of batteries will affect the marker
performance.
Adjusting the Sear Height
To adjust the sear height, there is a set screw in
the lower vertical arm of the sear that contacts
the front of the solenoid. If it is necessary to
raise the sear to engage the rear bolt, insert a
0.50" allen wrench past the side of trigger and
turn the allen wrench counter clockwise. Make
adjustments while the trigger frame is off the
receiver (body) and the marker is degassed.
Look down from the top of frame to help locate
the set screw. Only turn the Allen wrench 1/8
turn at a time and check engagement after each adjustment. Once the sear begins
to engage the rear bolt, turn the set screw an additional half to 1 full turn.
7. Rip Clip™ Operation (some models)
Rip Clip™ Features and Specifications
Power requirements: 4AA batteries (not included)
Capacity: 200+ paintballs
Feed Rate: 20bps+
Construction: Nylon
Auto-Off 1 Hour
Low Battery Indicator
Ultra-Quiet Belt Drive
FIRING MODES 12
1. PSP RAMPING(13 BPS) OFF OFF
2. PSP RAMPING(10 BPS) OFF ON
3. NXL FULL AUTO (13 BPS) ON OFF
4. NXL FULL AUTO (10 BPS) ON ON
Above settings are with jumper ON. With jumper OFF, firing is semi-auto regardless of DIP settings.