Owner`s manual

EMPIREPAINTBALL.COM
2
Always keep your Marker pointed in a safe direction. Always use a barrel plug
or barrel blocking device. Always use
paintball specific eye protection which
meets or exceeds ASTM standards in any
areas where paintball markers may be
discharged. Remember that the ultimate
safety device is you, the operator.
Safe Mode (all models)
In this manual, you will see the term
“SAFE” mode. The Power should be Off on
electronic grips, or the Safety should be set
to “Safe” (red marking on safety will not be
visible). Make sure your marker is set to
“SAFE” mode when indicated to do so.
Barrel Installation (all models)
Make sure marker is degassed, hopper
removed, no paintballs in the feed port or
breech and the marker is in “Safe” mode.
1. While pointing marker in a safe
direction, place the threaded end of
the barrel into the front opening of the
marker body.
2. Turn the barrel clockwise until it stops
(do not over tighten).
3. Adjust the barrel accessories if necessary.
4. Install a barrel blocking device. This can be a barrel plug or other such device that
prevents the accidental discharge of a paintball.
Battery Installation/Replacement (some models)
Electronic Grip Battery Installation
1. Using a Phillips screwdriver, remove the two grip screws on the left side of the frame.
2. Install a 9-volt battery into the electronic grip.
3. Re-install the two grip screws.
Rip Clip Battery Installation
1. Remove the screw on top of battery door.
2. Install 4 x AA batteries following the polarity
marking.
3. Reinstall the battery door screw.
Note: Always use quality, name brand batteries.
Using other types of batteries will affect the Rip-
Clip™ and electronic grip’s performance.
Feed Elbow/Rip-Clip and Loader Installation
Standard Feed Elbow
1. Press and hold the retention button located on the side of the Slide-Away™ elbow.
2. Slide the elbow onto the front of the picatinny rail.
3. Line up the elbow with the feed hole on the right side receiver.
4. Check that the elbow is locked in place and properly aligned.
Note: Spring-loaded retention button must line up in a gap on the picatinny rail.
Delta Feed Elbow
1. Loosen up the thumb nuts on the Delta elbow.
2. Clip onto the picatinny rail, left side first.
3. Make sure the feed holes are aligned.
4. Tighten up the thumb nuts.
Standard Loader
1. To install a loader check the Slide-Away™ elbow /
Delta elbow and loader to make sure they are free
from debris and obstructions.
2. Position Slide-Away™ elbow / Delta elbow onto your marker’s receiver.
3. If equipped with a clamping screw, use a 3/16" hex wrench, loosen the clamping screw
SAFETY OFF
SAFETY ON