Owner`s manual

EMPIREPAINTBALL.COM

Marker double firing or going full auto• Air cylinder low on air • Get air cylinder filled

• Rear bolt o-ring worn or damaged • Replace rear bolt o-ring

• Rear bolt or sear worn • Inspect both for wear and replace if needed

• Rear bolt has no oil • Oil rear bolt o-ring area with paintball oil

• Bad valve• Service or replace valve

• Sear height is improperly adjusted• Adjust sear height (Electronic Grip models only)

Marker does not re-cock• Rear bolt o-ring worn or damaged • Replace rear bolt o-ring

• Rear bolt o-ring is dry• Oil rear bolt o-ring area with paintball oil

• Power tube is damaged • Replace power tube

• Sear height is improperly adjusted• Adjust sear height (Electronic Grip models only)

• Marker internals clogged • Clean dirt and/or broken paintballs from inside receiver and barrel

Marker leaking out of barrel• Valve leaking • Service or replace valve

Marker leaking at ASA• Tank o-ring damaged or missing • Replace tank o-ring

• Tank or ASA damaged • Replace tank and/or asa if needed

Electronic Grip is not working • Battery is low on power • Install new battery

• Battery is of low quality • Buy better name brand batteries

• Sear height is improperly adjusted• Adjust sear height

• Board connectors are loose • Check that connectors are plugged in fully

• Electronics are damaged • Replace damaged parts

Rip-Clip™ is not working • Battery is low on power • Install new battery

• Battery is of low quality • Buy better name brand batteries

• Batteries are installed incorrectly • Check the polarity markings

• Drive cone is not pre-loaded • Pre-loaded drive cone spring

• Rip-Clip™ not properly aligned on marker • Position so feed holes match up

Marker is breaking paint • Velocity is too high • Lower velocity by turning screw clockwise

• Paint is of low quality or old •

Try better fresh paint

• Ball detent damaged or backwards • Replace detent or check if its in backwards

• Apex barrel is dirty • Clean apex barrel

• Apex ramp is set to high• Lower the ramp setting

Marker is double feeding • Ball detent is damaged • Replace ball detent

Paintballs not feeding into marker• Rip-Clip™ not installed correctly • Check Rip-Clip™ is installed correctly

• Rip-Clip™ is not turned on • Turn on Rip-Clip™

Velocity is low (Do NOT Exceed 300 FPS) • Velocity screw is in too far• Turn the screw counter-clockwise to increase velocity

• Air source is low • Get air cylinder filled

• Power tube is damaged • Replace power tube

• Drive spring is weak • Install a stiffer drive spring

Velocity is high (Do NOT Exceed 300 FPS) • Velocity screw is out too far• Lower velocity by turning screw clockwise

• Drive spring is

too stiff• Install a lighter drive spring

PROBLEM DIAGNOSIS SOLUTION