Owner`s manual

EMPIREPAINTBALL.COM
10
Receiver (Body) Separation (all models)
To fully access the internal receiver components, these parts must be removed first:
• Barrel
• Feed Elbow /Rip clip
• Sight rails
• Foregrip/Magazine
• Grip frame
Make sure the marker is in the un-cocked (forward position) before taking body apart.
1. Remove the bolt handle cover (rubber bonnet).
2. Lay on a flat surface with the left name plate facing up.
3. Remove the four upper receiver retention screws.
4. Lift name plate receiver away from other receiver half.
Note: The end cap/stock will be under some spring tension and may spring out
when the top name plate receiver is
lifted off.
Note: The retention screw located
below the bolt handle slot is longer
than the rest.
Removing End Cap/Stock,
Spring Guide, Bumper and
Spring
1. Lift end cap/stock
out of the right
upper receiver.
2. Remove the
bumper O-ring.
3. Remove spring and
spring guide.
Removing Rear
Bolt, Cocking
Handle and
Linkage Arm
1. Rotate rear bolt
counter-clockwise.
2. Remove linkage
arm.
3. Remove bolt
handle.
4. Slide the rear bolt
rearward and
remove.
Removing Barrel Adapter, Ball Detent and Front Bolt
1. Lift away Barrel Adapter (and barrel if still installed).
2. Lift out Ball Detent; notice its position before removing it.
3. Slide the Front Bolt forward and off the power tube.
Reassembly
To reassemble the marker, reverse the Disassembly instructions starting with the
barrel adapter, ball detent and front bolt removal. While reassembling the marker,
you should oil all O-rings and sliding parts. All parts and o-rings returned to the
marker should be free of debris and visual nicks and scratches which can alter the
performance of the marker. All screws returned to the marker must be tightened so
there is no chance of them vibrating loose.