Owner`s manual

EMPIREPAINTBALL.COM

2. Lift the feed elbow away from the receiver.

3. Lift off the receiver.

Rip Clip™

1. Loosen the two thumb nuts.

2. Lift the Rip Clip™ away from the receiver.

3. Lift off the receiver.

Front Foregrip

Removal

1. Turn the

vertical foregrip

bolt counter

clockwise to

allow retention

pin to drop. A

coin may be

used to assist

in turning the

vertical foregrip

bolt.

2. Slide foregrip to

preferred location or remove if so desired.

3. Reverse process to replace foregrip.

Sight Rail Removal

Rear Notch Sight

1. Using a 1/8" Allen wrench, loosen the rear sight retaining screw.

2. Slide sight of the picatinny rail.

Delta Sight Rails

1. Remove the Delta Feed Elbow / Rip Clip™ and barrel assembly.

2. Slide the small front sight rail forward and off the receiver.

3. Loosen the 3 screws with a Phillips screwdriver on the left side of the rear sight rail.

4. Slide the sight rail toward the back of the marker and remove.

Note: It may not be necessary to loosen the 3 screws on the Delta rear sight, see if

it slides off first.

Trigger Frame Removal (all models)

1. Extend the stock on all Delta models.

2. Remove the two grip retention screws from the pistol grip.

3. If the acorn shoulder nuts located in the pistol grip do not fall out after the screws

are removed, then press them out with a small hex wrench or screwdriver.

4. Lower the frame from the receiver.

Note: The frame will still attached to the receiver by the steel braided hose. It is

recommended

that you do

not remove the

hose from the

valve or the tank

adapter.