Instruction manual

1070 072 163-101 (97.11) GB

BTSMADAP & BTS_ZV Function Modules 5-1

5 BTSMADAP & BTS_ZV Function Modules

5.1 BTSMADAP Function Module

The BTSMADAP function module prepares the data from the program-

mable logic controller (PLC) for the operator terminal, and transfers re-

quests issued by the operator terminal to the PLC. The relevant

parameterization is almost identical for all controller variants

. In the case

of the CL200, the respective module number for the KETTE200 function

module must be taken from the symbol file and transferred to parameter

P1 in the form of a decimal constant. This results in the subsequent mod-

ule calls discussed in 4.2 and 4.3, below, that can be loaded into the

module editor by means of the Load Parameter List function of the pro-

gramming device.

5.1.1 Module Functions

The BTSMADAP module

• controls the manual operation,

• calls up the diagnostic module,

• prepares the diagnostic data stored in DM120 for display on the

operator terminal,

and

• controls the status display,

as well as the

• status messages.

In order to handle the described tasks, the BTSMADAP module requires

two data modules — one for processing the diagnostic data, and the other

for general communications between operator terminal and PLC.

Applies to CL200 with BTSMADAP, version 1.1 and higher.