Instruction manual

1070 072 163-101 (97.11) GB

CL350 / CL400 / CL500 Control Functions4-10

4.4.5 D6 — Selected Operating Mode

Further to the operating modes discussed in the preceding sections, the

D6 data word in the cascade data module contains additional information

relative to operating modes.

D6 nnBaWahl

This data word is written to by the KETTE cascade management module

via parameter P1 (-BETR).

D6.0 Manual mode H

D6.1 Inching mode T

D6.2 Automatic mode

D6.3 Start s

D6.4 S + 1

D6.5 Set Step

D6.6 Fault acknowledgement

D6.7 Reset

D7.0 Halt h

D7.1

D7.2

D7.3

D7.4

D7.5

D7.6 WSB does not reset BEFA (Manual only)

D7.7 Fault requires acknowledgement

Fig. 4-6 D6 — Selected Operating Mode

D6.0 Manual Mode

Define Manual mode.

D6.1 Inching Mode

Define Inching mode.

D6.2 Automatic Mode

Define Automatic mode.

D6.3 Start

Start / Command output enable

The bit is valid for all operating modes, and is statically transferred to pa-

rameter P1 of the KETTE cascade management module.

If Start = 0

bin

, the following will occur:

• BEFA is deleted

• monitoring time is halted

• wait time continues to elapse

To generate the cascade data modules, and to effect synchronization in

Automatic mode, the Start instruction must be deleted.