Instruction manual

1070 072 163-101 (97.11) GB

CL200 Control Functions 3-11

3.4.5 D6 — Selected Operating Mode

Further to the operating modes discussed in the preceding sections, the

D6 data word in the cascade data module contains additional information

relative to operating modes.

D6 nnBaWahl

This data word is written to by the KETTE200 module.

D6.0 Manual mode H

D6.1 Inching mode T

D6.2 Automatic mode

D6.3 Start s

D6.4 S + 1

D6.5 Set Step

D6.6 Fault acknowledgement

D6.7 Reset

D7.0 Halt h

D7.1

D7.2

D7.3

D7.4

D7.5

D7.6 WSB does not reset BEFA (Manual mode only)

D7.7 Fault requires acknowledgement

Fig. 3-6 D6 — Selected Operating Mode

D6.0 Manual Mode

Define Manual mode.

D6.1 Inching Mode

Define Inching mode.

D6.2 Automatic Mode

Define Automatic mode.

D6.3 Start

Start / Command output enable

The bit is valid for all operating modes, and is statically transferred to D6.

If Start = 0

bin

, the following will occur:

• BEFA is deleted

• monitoring time is halted

• wait time continues to elapse

This option applies to the CL200 with firmware version 1.5 and higher.