Instruction manual

1070 072 163-101 (97.11) GB
Appendix11-8
11.3 Fault Messages
Code Subcode
dec
Subcode
hex
Fault Fault description
0 0 0 NO ERROR Fault-free processing.
1 1 1 E SLAVE NOT READY Level 1 and level 2 fault.
1 2 2 E PROTOKOL Packet sequence.
1 3 3 E FRAME Protocol frame fault.
1 4 4 E TIMEOUT Timeout fault.
1 5 5 E CRC BCC CRC fault.
1 6 6 E PARITY Parity fault.
1 7 7 E SEND ABORT Transmission abort.
1 8 8 R REC ABORT Reception abort.
1 9 9 E BUF SIZE Cyclical buffer too small.
1 10 A E NO DEFINE No cyclical data defined.
1 12 C E DEFINE Cyclical data already defined.
1 15 F E NO PROTOKOL Selected protocol is not supported.
1 16 10 E OVERRUN Reception overflow.
1 40 28 E SYS ADDRESS Illegal system variable.
1 50 32 E QUITTUNG START No connection established.
1 51 33 E QUITTUNG OPEN Invalid connection setup acknowledgement.
1 52 34 E QUITTUNG DATA Wrong acknowledgement on transmitted infor-
mation block.
1 53 35 E NO RESPONSE
WRONG CHAR
No response telegram.
1 54 36 E TIMEOUT NO RE-
SPONSE
Timeout - No response telegram.
1 55 37 E TIMEOUT BLOCKZEIT Timeout - Block time exceeded.
1 56 38 E TIMEOUT QUIT RE-
SPONSE
Timeout - No acknowledgement.
1 57 39 E ABBRUCH SPS End Of Text marker (EOT) - PLC abort.
2 58 3A E RECEIVE COUNT Wrong data size received. Check and verify
whether, in the mask in which the fault occurs, a
variable with odd number of bytes is being read
from a word or double-word address.
Fig. 11-2 Fault Messages