Instruction manual

1070 072 163-101 (97.11) GB
Tesi Mod Software Installation 10-1
10 Tesi Mod Software Installation
Both the TS Programming System software (briefly referred to as "TS")
and the menu trees are shipped on individual 3.5 inch diskettes. As a first
step, the installation program on the diskette is used to install the TS ap-
plication. Next, the menu tree data and the PLC files associated to ma-
chine control functions are copied from the diskette into the respective
PLC directories.
10.1 Installing the Software
The installation diskette is loaded into the 3.5 inch disk drive (drive letter
A:\ or B:\). Starting at the command line of the current directory, you
start the installation program by typing:
A:\INSTALL Or, if the installation diskette is in the B:\ drive,
B:\INSTALL
and by pressing [RETURN].
The German-language sign-on screen shown below is displayed. It en-
ables you to select both the destination drive and destination directory for
the installation.
Fig. 10-1 TesiMod Sign-On Screen and Installation Start Menu
The default settings of C:\ (Ziellaufwerk = destination hard disk) and \TS4
(Zielverzeichnis = destination directory) can be changed. Pressing the
[CURSOR UP] and/or [CURSOR DOWN] key switches the cursor to the
respective entry option. Invalid drive destinations and/or directory names
will cause a cautionary message to be returned, and must me changed.
At this point, the installation procedure can be cancelled by pressing the
[ESCAPE] key.
It is instructive to note that the installation routine is fully automatic, and
does not require user intervention. However, to avoid confusion, the two
German-language messages appearing during the installation procedure
are translated below.
Pressing the [SHIFT+F10] shortcut starts the installation.
TesiMod
Installation des Programmiersystems TS
Installation vom Laufwerk A:
Ziellaufwerk : C
Zielverzeichnis : \TS4
Mit der Funktionstaste Shift+F10 starten Sie die Installation