Instruction manual

1070 072 163-101 (97.11) GB
TS Programming System 9-19
9.4 Procedural Description
The procedural description encompasses the complete sequence of
events, starting with the copying of the menu tree from the supplied pro-
gram diskette, and concluding with the transfer of the completed menu to
the respective operator terminal.
To facilitate enhanced understanding of procedural steps, the subsections
of Section 8.4, "Procedural Description" shall utilize the procedural steps
associated with the project labelled MACHINE1 and the BT20 operator
terminal plus the CL400 controller. Only with regard to mask descriptions
will parallel procedural steps apply to the BT5 operator terminal. Through-
out the remaining subsections, the description of procedures will be re-
stricted to those required for the BT20 operator terminal. These steps are
listed analogous for the BT5 operator terminal, whereby merely the file-
names and directory names must be replaced.
9.4.1 Copying Data From Program Diskette
For the BT20 operator terminal and the CL400 controller, the required
data must be copied from the program diskette into the working project di-
rectory. The project directory named C:\PG\MACHINE1.C00 was previ-
ously created by means of the PLC software.
To create the menu tree directory, use the following command:
• MD C:\PG\MACHINE1.C00\BT
Copying files supplied on BT-MADAP program diskette:
• COPY A:\BT20\BT20.TSG C:\PG\MACHINE1.C00\BT
• COPY A:\BT20\BT20_400.PRJ C:\PG\MACHINE1.C00\BT
• COPY A:\BT20\BT20_4_5.TSM C:\PG\MACHINE1.C00\BT
• COPY A:\BT20\BT20_400.TSV C:\PG\MACHINE1.C00\BT
• COPY A:\CL400\*.* C:\PG\MACHINE1.C00\ZSO
(For detailed information,
see Chapter 9, "Installing TS Programming System.")