Instruction manual

1070 072 163-101 (97.11) GB
TS Programming System9-18
The list of all available variables is displayed in the Bosch BUEP19E Pro-
tocol window. A new variable can be inserted at the end of the variables
list, or inserted into the list with the use of the Edit menu, and the Insert
line menu command. For the new variable, the name (use of the variable
in a mask of this name), and the relation to the controller variables, must
be established. To accomplish this, the values of the controller variable to
be assigned must be entered in the list columns labelled Data type, Ac-
cess, Parameter1, Parameter2 and Slave.
If a new variable is entered into a mask, a format that determines its dis-
play within the mask must be attached to it during the insertion procedure.
9.3.7 Parameters
The parameters file provides the means for adjusting various parameters
that regulate, for example, the communications between controller and
operator terminal. As the predefined menu trees contain the settings that
are configured for both the respective controller and operator terminal, no
modifications will be normally required here.
However, if adaptations should be required, more detailed information can
be taken from the technical manual. Also the procedure for changing pa-
rameters, as outlined in the User Manual furnished by SÜTRON elec-
tronic GmbH, must be observed.