Instruction manual

1070 072 163-101 (97.11) GB
TS Programming System 9-13
9.3.4.2 BT5 – Power-Up Conditions Mask
The description of one Power-up Conditions mask (here, M20-1) also ap-
plies to the remaining Power-up Conditions masks.
The Power-up Conditions mask can be used to display the various pre-
conditions existing for the start of the controller. A total of 4 masks is
available.
The contents of these masks may be freely configured.
In the example used in the present section, two fixed texts and two vari-
ables are inserted into the Power-up Conditions mask.
Mask 20
Hydraulic pump On Ó
← E_HPumpe
Lubrication pump
On Ó
← E_SPumpe
Fig. 9-20 Example of BT5 — Power-Up Conditions Mask
Ó : Placeholder (also: wildcard character) for variable.
9.3.4.3 BT5 – Display Mask
The description of one Display mask (here, M110 - Group 1/1) also ap-
plies to the remaining Display masks.
The display masks are used to indicate several current controller
statuses. A total of 16 Display masks is available.
In the example used in the present section, two fixed texts and two vari-
ables are inserted into the Display mask.
Mask 110
Part A
Processing Ó
← E_TeilA
Part B
Processing Ó
← E_TeilB
Fig. 9-21 Example of BT5 Display Mask
Ó : Placeholder (also: wildcard character) for variable.