Instruction manual

1070 072 163-101 (97.11) GB
TS Programming System 9-1
9 TS Programming System
9.1 Introduction
The TesiMod Programming System software – also referred to as TS
Programming System – is used for programming tasks on the BT5 and
BT20 operating terminals.
For the referred terminals, completely predefined screen masks and
menus – generally called menu tree – are provided. There is a slight dif-
ference between the menu trees for the BT5 and BT20 operating termi-
nals. The benefit of the menu trees is that the entire programming
requirement for a given terminal is reduced to making minor touch-up cor-
rections to several display masks.
The present chapter discusses the utilization of the preprogrammed TS
software, i.e., its menu tree, and its adaptation to the functions and fea-
tures of the respective BT5 and/or BT20 operator terminal.
More detailed information can be found in the technical manual, and in
the User Manual provided by the firm of
SÜTRON electronic GmbH
Kurze Strasse 29
D-70794 Filderstadt / Germany.
9.2 Menu Tree
The supplied software includes the menu tree for the BT5 and BT20 op-
erator terminals (differentiated by PLC controller variants), as well as the
PLC software modules for the CL200, CL400, and CL500 control units.
In the event that several projects are being handled, each project will be
allocated its own menu tree.
As a separate menu tree exists for each operator terminal and each con-
troller, the menu trees for the BT5 / CL200 and BT20 / CL400 terminal /
controller combinations shall be used as standard examples throughout
the following sections.
The software data encompasses four files for each menu tree, listed in
the table below.
BT5 / CL200 Filename Explanation
BT5_200.PRJ Project definition
BT5.TSG Definition of parameters
BT5_200.TSM Mask definitions
BT5_200.TSV Definitions of variables
BT20 / CL400
BT20_400.PRJ Project definition
BT20.TSG Definition of parameters
BT20_4_5.TSM Mask definitions
BT20_400.TSV Definitions of variables
Fig. 9-1 BT Project Files