Instruction manual

1070 072 163-101 (97.11) GB
1-6 Safety Instructions
CAUTION
Danger to the module!
All ESD protection measures must be observed when using the
module! Prevent electrostatic discharges!
Observe the following protective measures for electrostatically endan-
gered modules (EEM)!
• The Employees responsible for storage, transport and handling must
be trained in ESD protection.
• EEMs must be stored and transported in the protective packaging
specified.
• Out of principle, EEMs may be handled only at special ESD work sta-
tions equipped for this particular purpose.
• Employees, work surfaces and all devices and tools that could come
into contact with EEMs must be on the same potential (e.g. earthed).
• An approved earthing wrist strap must be worn. It must be connected
to the work surface via a cable with integrated 1 MW resistor.
• EEMs may under no circumstances come into contact with objects
susceptible to accumulating an electrostatic charge. Most items made
of plastic belong to this category.
• When installing EEMs in or removing them from an electronic device,
the power supply of the device must be switched OFF.
1.6 Trademarks
All trademarks referring to software that is installed on Bosch products
when shipped from the factory represent the property of their respective
owners.
At the time of shipment from the factory, all installed software is protected
by copyright. Software may therefore be duplicated only with the prior
permission of the respective manufacturer or copyright owner.
MS–DOSr and Windows™ are registered trademarks of Microsoft Corpo-
ration.