Instruction manual

1070 072 163-101 (97.11) GB
BT20 Menu Descriptions 8-3
8.2 Setup Menu
The Setup menu (mask number M1) provides the options to change the
terminal initialization data, and the configuration data for the X2 commu-
nications interface, without the use of a programming device.
SETUP - MASKE
Baudrate X2 : 38400
Parity X2 : Even
Datenbits X2 : 8
Stopbits X2 : 1
Datenübernhme : inaktiv
Protokoll-Software: BP19E4.5
Terminal-Software : HB000045
Datum : 16.06.95
Uhrzeit : 8:15:00
Display-Kontrast : <<<<
Download : inaktiv
Fig. 8-2 BT20 Setup Menu
The Edit mode is toggled On and Off by pressing the [EDIT] key. The
changes are made by means of the [+/-] key.
The cursor movement from one field to the next or back again is con-
trolled by the [CURSOR DOWN] and [CURSOR UP] keys.
A Download sequence is initiated by selecting Download aktiv, and sub-
sequent confirmation by pressing the [ENTER] key. Once the Flash-
EPROM has been flushed, the operator terminal is again set to Download
mode.
In the event that X2 interface configuration data is modified, each change
requires confirmation by pressing [ENTER]. The transfer of setup data is
effected only subsequent to pressing the [ENTER] key, and switching Off
the Edit mode by pressing the [EDIT] key.