Operation Manual

Diverse 3010 Executive – Edition 4 – 22 November ’00 - 3509
32
Note
The barred or enabled numbers must
be switched on before you can use this.
To switch call barring/call
enabling on and off
Once you have set the numbers
you want, you can then switch
call barring/ enabling on or off
at any time (see below). You
can do this from any handset
registered to the base station.
Press the
INT button.
Press the
SET button.
Press the
0 button twice.
Press the
OK button.
Enter the base station PIN
(original setting
0000 ).
Press the
OK button.
Press
1 to bar the numbers
you have stored.
Press
3 to enable handsets to
dial only the numbers stored
Press
0 to switch call barring/
call enabling off.
Press the
OK button to confirm.
Press the
RED PHONE button
to return to standby.
INT
SET
0
1
3
DEF
0
OK
OK
OK
KEYPAD
SECURITY
Base Lock Set
00
OK
➜
Press the UP/DOWN buttons
if necessary to scroll to the
location you want 1-5 .
Press the
OK button.
Enter the number you want to
bar, enable or change. Press the
DELETE button to delete digits.
Press the
OK button to confirm.
Press the
RED PHONE button
to return to standby.
➜
OK
OK
Diverse 3010 Executive 22/3/01 12:03 pm Page 32