User's Manual

ManualsBrandsBT ManualsPaintballBT Delta

Reassembly

To reassemble the marker, reverse the Disassembly instructions starting with the

barrel adapter, ball retainer and bolt removal. While reassembling the marker, you

should oil all O-rings and sliding parts. All parts and o-rings returned to the marker

should be free of debris and visual nicks and scratches which can alter the perform-

ance of the marker. All screws returned to the marker must be tightened so there

is no chance of them vibrating loose.

Storage and Transportation

1. BT Delta

must be clear of all paint and propellant when not being used.

2. Be sure to have marker in “SAFE MODE” when not in use.

3. Make sure barrel blocking devise is in place.

4. Store BT Delta™ and propellant in cool dry place.

5. Keep your BT Delta™ away from children without proper supervision.

6. Your BT Delta™ must be free of all paint and not attached to a propellant source

while being transported to and from the playing field.

7. Observe and obey all local, state and federal laws concerning the transportation

of paintball markers. For information concerning any of the laws in your area,

contact your local law enforcement.

(01) Magazine Expansion Chamber Removal

Using a 1/8" hex allen wrench, loosen and remove the two screws in the Air Source Adapter (ASA) to separate it from the trigger frame. Remove the

screw in the upper right corner of the magazine expansion chamber using a 5/32

" hex allen wrench. Remove this screw’s nut stem by pushing through

the hole with the 5/32" allen wrench. Grab the magazine expansion chamber by hand and pull straight down and out of its mounting collar. Remove the

two slotted thumb screws at the top of the mounting collar and remove the dovetail plate. Then slide the mounting collar forward to separate it from the

receiver.

(04) Bi-Pod Removal

Loosen the large thumbscrew on the underside of the bipod to separate it from the barrel.

(05 & 06) Combat Stock and Collapsible “CAR” Stock Removal

These stocks take the place of the rear receiver. When servicing the marker internally, make sure the spring guide and bumper o-ring are in place when

reassembling, or else damage to the receiver may result.

S.W.A.T.

BANSHEE

IRONHORSE

BT_DELTA_complete_manual.qxd 9/7/07 7:30 PM Page 9