User's Manual

BT DELTA Disassembly
Removing the Rip Clip
™
or standard side feed neck
1) Turn both locking screws counter clockwise until
they stop (Figure 1).
2) Gently pull then tilt the Rip-Clip away from the
body and remove.
Note: The Locking screws are spring loaded.
Body Sight Rail Removal
1) Remove the Rip Clip and Barrel assembly.
2) Slide the small sight rail spacer off.
2) Loosen the 3 screws on the right side of the sight
rail
(Figure 2).
3) Slide the sight rail toward the front of the marker
and remove.
Removing Barrel from the
Complete Barrel Assembly
1) Remove the barrel
assembly from marker.
2) Remove the Barrel plastic
foregrip by removing the
retention pin
(Figure 3).
3) Loosen the 2 set screws and
remove barrel
(Figure 3a).
Note: It is very important that
when installing the barrel back
into the barrel assembly that it
is properly aligned. The easi-
est way to align the barrel is to
remove one of the set screws
and line up the original mark
left by the set screw.
Front Barrel Sight Removal
1) Remove the screw located
in the front of the sight
(Figure 4).
2) Slide sight forward and
remove
Magazine and Magazine
Holder Removal
1) Push on the release tab to
remove the magazine.
2) Remove the 2 screws and metal plate
(Figure 5).
3) Slide the Magazine holder toward the front of the
marker and remove.
Magazine Adjustment
It is possible to slide
the Magazine assem-
bly to your liking
1) Remove the 2
screws and metal plate
2) Slide the magazine
assembly to new
location.
3) Reinstall the plate and
screws, making sure they
are going into a body notch.
4) Tighten screws.
Stock Length
Adjustment
1) Push the stock
adjustment lever to
the left and adjust
the stocks length by
pulling or pushing
on the back of the
stock
(Figure 6).
2) Make sure the lever
springs back to the
right to lock it in position.
Stock Removal
Same as other BT stocks.
Other Disassembly
Same as BT-4 Series.
Rip Clip Adjustment
See Rip-Clip instructions.
BT DELTA
(Figure 1)
(Figure 2)
(Figure 3)
(Figure 3a)
(Figure 5)
(Figure 6)
(Figure 4)
B
03
BT_DELTA_complete_manual.qxd 9/7/07 7:30 PM Page 4