Installation manual
11 Use the local phone to sign in by pressing * code #. Each key pressed
should be followed by a short beep tone to indicate that is has been
recognised The voice menu should be heard, and the DTMF keys should
be able to select the various menus.
12 Program and Record the following messages using the telephone:
- Greeting Message - Prog. Menu 1,3
(This may also be played on the doorphone, where required, involve
the customer)
- Alarm Message - Prog. Menu 3,5
(user, company name and address) Precedes all outgoing calls
- User Name - User Menu 2,6,2 (where required, involve the customer)
13 Press 5 for Voice Station to enter two-way communication with the
Keypad. You should be able to hear sounds on the Keypad. When you
talk, you should be heard on the Keypad. The conversation is
half-duplex, i.e. only one side can talk at a time.
14 Dial into the system. Ensure that the system answers the call after the
designated number of rings (5). Ensure that the system recognises the
DTMF keys, sign in by pressing * code #, you should then be able to
select the various menus. Each key pressed should be followed by a
beep tone to show that the key has been recognised.
15 Activate the Voice Station Menu remotely by pressing 5. You should be
able to hear sounds from the Keypad. Just like with the local phone,
when you talk you should be heard on the Keypad. If the sound on the
remote phone is cut off whenever someone talks on the Keypad,
reduce the level of the microphone trimmer. Excessive levels of
microphone background noise tend to fool the system into thinking that
the remote end is trying to talk, and hence to switch the direction of
the communications to “talk”.
16 If there are more than 1 Keypads, press F 8 to activate Intercom
mode. All other Keypads should hear voice from the originating
Keypad. Any keypress on another Keypad will shut off other Keypads
and allow that Keypad to talk with the originator. Any Keypad can talk
by pressing and releasing any key. Press F to end.
17 If there is a Door Station, pressing the button when Security is OFF
should cause the Keypad to give a door chime tone and will ring the
phone if a ringer is fitted. Use the local telephone to answer and talk
with the Door Station. Check that both sides can be heard clearly. If a
Response has been programmed into Location 52, press 7 to open the
door or gate.
18 The Keypad can also be used to talk to the Door Station. Only 1 side
can talk at a time. The Keypad controls the direction of the
conversation, by pressing 1 to alternate between talk and listen modes.
19 Program Alarm Type 25 to dial to a mobile phone, Arm the system to
Away Mode, and press the Doorbell. The system should call to the
mobile and allow you to talk to the Door Station after selecting ‘1’.
Comfort Installation Manual
93