Installation manual

example, when armed to Away, all the lights and appliances may be
turned off, or when disarmed, the heater can be turned on. To do this,
enter a Response number for each of the Security Mode Responses in
Engineer Menu 3,5. Arming to Holiday Mode activates the Away Mode
Response.
Table 31 - Event Triggered Responses
The Open Door 1 Response in Location 52 allows the Menu 7 to Open
Door in the Door Station menu
The Gate Response in Location 1686 allows the Menu 4 to Open Door in
the Door Station menu
The Doorbell Response in Location 1691 is activated when The Door
Station Doorbell is pressed (Default Response 233).
The Phone Ring Response in Location 1685 is activated when the Door
Station Button is pressed.
The AC Restore Response in Location 1847 is activated when the AC is
restored after a power failure.
The Start-Up Response in Location 1683 is activated whenever the
system is started up from power-off state. This may be used to set
Cameras to a desired normal view or to set flags etc. or relay outputs
to normal.
The Arming Response in Location 1850 is activated whenever the
system is arming. This may be used to reset latching shock detectors.
Table 32 - X10 Received Codes Responses
X10 Codes may be received via the X10 two-way interface. X10
commands from X10 switches or controllers may be used to trigger
any Comfort Response. One Housecode may be recognised,
programmed in Location 1851. The table shows the translation of house
codes A to P into the code to be programmed in Location 1851. For
example, if Housecode P is required, program Location 1851 with 80.
For the programmed housecode, unit codes 1 to 16 ON and OFF
commands as well as ALL Lights On, All Units Off may activate a
Response. For example if Unit Code 5 ON and OFF is to switch Output
1 on and off respectively , program Location 1860 with Response 1
(Output 1 ON) and Location 1861 with Response 2 (Output 1 Off).
Table 33 - Responses (Engineer Menu 3,6)
There are 255 responses or programs in the system. Each of these
Responses may be assigned to Time Programs, Holiday Programs, Zone
ON and OFF, Alarm activation, Security Modes, Control Menu, and
Keypad Function Keys. Responses perform functions like Output on/off,
transmission of Infrared Codes, transmission of X10 codes, auto arm
and disarm etc.. (see list of Default Responses and Actions). Most
Responses are pre-programmed to default functions, but any Response
may be redefined according to your requirements.
Comfort Installation Manual
83