Installation manual

No Action
if the Action key has not been programmed. Enter up to 3 words from
the wordlist (Table 40). If less than 3 words are entered, enter 255# as
terminator. "ON" is 230#. Enter 255# for terminator. The menu
announces the Actions words ("ON"), and asks for the Response
Control Response 0
Enter Response and # key
Enter the appropriate Response number from Table 33, which performs
the desired function. If no suitable default Response is available,
program an unused Response or reprogram a Response which is not
required.
Repeat for other Action Keys for this Control Key
Repeat the sequence for each Control Key, depending on how many
appliances are to be controlled by Comfort.
(( If the Control Menu is not programmed, (or more precisely,
Control Key 1 is not programmed), the User Menu will not
announce "4 for Home Control"
Location for Feedback Input (Table 26)
Each Control Key can be programmed to announce the status of the
appliance (On or Off). This is done by assigning an input (programmed
as Zone Type 8, Switch N/O) as the feedback input for the Control Key.
The feedback input comes from a Feedback Relay or AC Current Sensor
which senses the current flowing in the Appliance circuit. Figure 2.18
shows a typical circuit for two way control with feedback, where a
two-way swatch allows manual control by the user as well as control by
Comfort.
Table 26 shows which Location to enter the Zone or Input number
which provides the status feedback for each Control Key. When the
input number is entered into the correct Location, selecting the Control
key in the Home Control menu will give the following menu (example):
(appliance name ) ON (or OFF)
Press 1 for ON, 0 for OFF
The state of the appliance selected by the Control key is announced. If
the feedback input is ON (closed for Normally Open Zone Type), the
word for the status announcement is taken from the Action key 0 (for
Off) or 1 (for ON).
In figure 2.18, the appliance control is shown as via relay control, but
control by other means (X10 or Infrared signal) is equally applicable.
Programming for the two way switching is given in the Applications
Manual 4.2.
Comfort Installation Manual
80