Installation manual

Table 24 - Siren Duration
The duration for each Siren Type is programmed in 2 consecutive
Locations given in Table 24. The values to program in the two locations
are given in table 24 for a range of durations.
Table 25 - Siren Type (Output Settings)
Each Siren Type can be programmed to output to the Siren (12V),
Keypad or Door Station. It is always output to the Speaker (SPK+/-),
but if the HI SPK setting is on, it will be at full volume, not adjustable
by the VR3 trimmer. If HI SPK is programmed off, the VR3 trimmer
controls the volume of the siren at the speaker.
Table 26 - Control Menu (Engineer Menu 3,1)
The Control menu is for programming of the Home Control menu used
to activate the home automation functions.
The Control menu is in two levels. The first level (Control Key) selects
the appliance to be addressed, using the keys 0 to *. Once the
appliance is selected, the 2nd level (Action key) selects the action to be
performed for the selected appliance, also using the keys 0 to *.
Usually, 0 if programmed for OFF and 1 for ON.
Go to Control Settings (Engineer Menu 3,1). The system says
Enter Control Key
To program a Control Key, enter the key 0 to * , say 1, (without #
key). The Menu says
Control Key, 1
Press 1 for Description, 2 for Action Key
Press 1 to assign words to the Control Key.
Each Control Key can be described by up to 4 words from the Wordlist
(Table 40). To enter a word, enter the word number 0 to 254 and #
key. The menu announces the word after each * key. If less than 4
words are used, enter 255 as a terminator. Once a terminator or 4
words have been entered, the menu will announce the words entered.
After assigning words to the Control key, press 2 for Actions. The
menu says
Enter Control Action Key
Enter 0 to * to program the Action Key. Usually 1 is for ON and 0 is for
OFF.
To program 1 for ON, press 1 (without #). The menu says
Comfort Installation Manual
79