Installation manual

0 = Idle

1 = Trouble - for trouble conditions

2 = Alert - for alert or perimeter states

3 = Alarm - for full alarm

The alarm state defines the priority of the alarm.

2,80 to 3Alarm State

If the alarm type is Trouble state, whether the system may be

armed when the alarm type is still active. Setting this to off will

prevent the user from arming the system during this alarm.

This applies only for Trouble Alarms and has no effect for

alarms of other states.

2,7Yes/NoTrouble Arm

Determines if this alarm type is reported in the Event Log2,6Yes/NoEvent Log

RemarksMenuValueItem

Table 21 - Other Dialout Parameters

Dial Delay (seconds)

This is the common delay time in seconds which is applicable whenever

Alarm Types are set for Dial delay.

Siren Delay (minutes)

This is the global delay time in minutes applicable when Alarm types are

set for Siren delay. When the value is N, the actual delay time could

range from N-1 minutes to N minutes. This value is only applicable

where Siren Delay has been selected in the each particular Alarm Type.

Number of Redials

This sets the limit for the number of redials to each phone number if

the outcome is not successful, i.e. busy, no answer, or no

acknowledgment.

Redial Time (seconds)

This is the delay after an unsuccessful call before Comfort redials the

same number.

Table 22 - Siren Types

Comfort has 20 Siren Types or patterns to cater for different audible

indications. Each Alarm Type is assigned a Siren Type. Siren Type

settings are not available directly in Engineer Menu, they can be

changed using Locations, as given in the Worksheet. It is not necessary

to change Siren type settings unless there is a special requirement.

Table 23 - Sound Types

Each Siren Type is assigned a Sound Type, which determines the

frequency of the sound on the speaker (but not the 12V Siren), and the

cadence or on-off pattern. The Sound Type of each Siren Type can be

programmed in the Locations given in table 22. The list of available

Sound Types is in Table 23. It is not necessary to change the default

Sound Types

Comfort Installation Manual