Installation manual

Program and Engineer Menus
There are 2 levels of programming access,
1 Program Menu - allows a master user to change settings pertaining to
the answering machine, home automation and certain security
features. Program Menu is accessible from the user Master Code (User
Menu 9) as well as Engineer Menu 9. This is described in detail in the
Program Menu Reference (User Reference Manual)
2 Engineer Menu - Allows change in security, zone, home automation and
alarm settings. This is described in detail in the Engineer Voice Menu
Reference. Engineer Access is enabled by setting the Engineer Sign-in
Option ON in the User Program Menu (3 - Security Settings, 4 -
Engineer Sign-in option). If this setting is OFF, the Engineer code will
not be allowed to gain access to the Engineer Menu. This is
automatically disabled each day at midnight and when the system is
armed, as a safety precaution.
Programming Modes can be accessed from the Keypad, any house
phone, or remotely, by dialling from any tone-dialling telephone.
CS-Xpress for Windows 95/98 is also available to do programming from
a PC.
Entering Engineer Menu
If no Engineer Code has been programmed, the default code is 6789#.
The Engineer Sign-in Option must be enabled on the Program Menu in
order to gain access using the Engineer Code.
To enable Engineer Code,
w Enter the Program Menu, press 3 for Security Options, 4 for Engineer
Sign-in Option and 1 to set it to ON
w Alternatively, on the Keypad, press F+ 0 which is default-programmed
to enable Engineer Sign-in Option. This key can be programmed to dial
to one of the programmed phones, i.e. the Engineers telephone
number, to allow remote programming. This is done by enabling the
dialout option in Alarm Type 30, and turning on the required phone
index 1 to 8
The Engineer Sign-in Option is OFF by default, and is turned off when
System is Reset (pressing Reset button, not rearm), and is
automatically disabled each day at midnight, and also when the system
is armed This option gives the user assurance that installers cannot
access their system without their authorisation.
To enter Engineer Programming mode, either
w Use any Keypad or house phone and enter * (Engineer Code) #, or
w Dial the phone number where the system is installed. When the system
answers the call and plays the Greeting message, enter * (Engineer
Code) #. This is possible provided the phone is not answered by
anyone on the premises.
Comfort Installation Manual
63