Installation manual

Power-On Checklist
1 Check that Keypads and Door Station wiring are connected, the ID
jumpers for each Keypad and Door Station are set correctly. At least 1
Keypad should be connected for easy programming
2 Measure and log the functional resistance of each detection circuit
3 Terminate all zone wiring into the respective Zone Terminal Blocks on
the Main board or Local Expansion Module (LEM) and label accordingly.
Connect detector 12V supplies to the auxiliary 12V output terminal
block.
4 Check all zone jumpers are in the double EOL (away from terminal
blocks) or no EOL positions (nearest the terminal blocks).
5 If U4 has been previously programmed off site, then check that the
correct (Non volatile Memory) NVM is inserted the right way round in
the socket marked U4.
6 Apply mains power without the battery. Observe the red and Green
LEDs on the main board while the system is going through its
self-testing cycle. Both LEDs should turn on when power is first applied.
After a second, the red led should turn off. After around 5 seconds, the
green led which was on should go off for a second and turn on again.
This indicates that the Voice system and the U4 NVM has been checked
and is the correct version. If things go wrong here, refer to the
section on “Troubleshooting”
7 The Keypads should announce “Security Off”.
8 Enter *1234# on each Keypad. The User Voice Menu should be heard.
End by pressing the F (Function) key, and go on to the next Keypad.
9 If there is a Door Station, press the Doorbell button. The doorbell
chime should be heard on the Keypads. Press any key on any Keypad
and “Press 1 for Door Station” to talk to the Door Station. Only the
Keypad or Door Station can talk at any one time, with the Keypad
controlling the direction of the conversation. Press 1 to alternate
between listen and talk.
10 Press the Night Mode one-touch key (with the Moon Icon) on any
Keypad. After a few seconds the Keypads should announce “Night
Mode” . The Red LED should come on and the Green LED go off on the
Keypad.
11 Exit from the Keypad menu by pressing F. Test the local phone
operation by lifting the handset or press Handsfree button, press *
within 5 seconds, followed by user code 1234 then #. You should hear
the Voice Menu. Press some keys to go into various menus to verify
that the local phone access is working. If you cannot get into the Voice
Menu, see the “Troubleshooting” Section.
12 The system is ready for programming, either using CS-Xpress for
Windows 95/98 or by Keypad. If you cannot get to this point, refer to
the section on “Troubleshooting” for ideas on what may have gone
wrong.
Comfort Installation Manual
55