Installation manual

should be multiplied by the minimum time duration that is required

under the relevant standards. The Amp/hour battery size should be of a

higher capacity than the result of the calculation. It is always advisable

to install the highest capacity battery which can physically fit into the

enclosure (7A/hr).

E.g.: QC = 0.650 A (650 mA)

8 hours required stand by

QC x 8 = Battery Size A/hr (Min)

0.650 x 8 = 5.2 Amp-hour, Next available Battery size is 6

Amp-Hour

Factory Restart

Comfort does not have a factory restart setting. The configuration is

stored within U4 Non-volatile memory (NVM), so either this can be

replaced with a formatted U4 with default values or you can use

CS-Xpress to overwrite the current configuration with a default

template. You can write a default NVM using the UCM01 module’s copy

socket by inserting a master default NVM placing a spare 24LC65 IC in

the copy socket and pressing ‘Copy’ on the UCM01 local button. This

takes around 12 seconds to write.

Comfort Installation Manual