Installation manual

Zone tampered with followed by Zone number .RestoreZone Trouble
Zone with alert zone type activatedN/AZone Alert 1-24
A problem occurred with the Voice Engine, which was reset to clear the
problem.
N/AVoice Reset
Warning Alarm Activation followed by Zone number. e.g. Water
Leakage
RestoreWarning Alarm
System is armed to Holiday ModeN/AHoliday Mode
Panel (J4), Bell tamper -Tamper Alarm 1, Keypad - Tamper Alarm 65 to
72 , Door Stations - Tamper Alarm 49 to 51.
RestoreTamper Alarm 1 or
Tamper Alarm 49+/65+
More than six unsuccessful attempts to sign-in at the Keypad while the
system is armed.
RestoreSign-In Tamper
System reset using Reset Button, Engineer Menu or CS-Xpress.N/ASystem Reset
Monitored Siren output (SRN-,SRN+) has a broken wire or ground fault.RestoreSiren Tamper
System Armed to one of the three modes.N/ASystem Armed
The system is disarmed and unset.N/ASecurity Off
Mains Power RemovedRestorePower Failure
System attempted to dial telephone number 1-8.N/APhone Number 1-8
Telephone line cut or phone in parallel and ‘off hook’ on Comfort Tel In.RestorePhone Trouble
Perimeter Alarm Activation followed by Zone number.N/APerimeter Alarm Zone
1-24
Successful dial-out to pager with correct acknowledgementN/APager Dial OK
Panic Alarm Activation followed by Zone number.RestorePanic Alarm Zone 1-24
System Armed to Night Mode - Part Set.N/ANight Mode
N/AMonitoring Station
Valid user code 1-16 entered remotely using external phone.N/AMailbox No. Phone Call
Sign-In Code
Valid user code 1-16 entered using local phone or Keypad.N/AMailbox No. Sign-In
Code OK
Intruder Alarm Activation followed by Zone number.N/AIntruder Alarm Zone 1-
24
System armed using a response linked to a zone-switch or function keyN/AKey Arm
Fire Alarm Activation followed by Zone number.RestoreFire Alarm Zone 1-24
During Exit, the hash key was pressed to force arm the system.N/AForce Arm
The Engineer has entered the system using the Eng Access code.N/AEngineer Menu
The Engineer has reset the system following Alarm Activation, using *.N/AEngineer Reset
(UK Only)
A valid user code was not entered within the entry timer duration. N/AEntry Alarm
System dialled engineer via a response linked to a function keyN/AEngineer Menu Phone
Call Sign-In
DescriptionRestoralVoice Event
Printing the Event Log
Comfort Installation Manual
126