Installation manual

Voice Phone (or pager)
Enter new number and # key
Enter the new number and #, or just # to leave the number
unchanged.
If you make a mistake while entering the phone number, press * or the
AWAY key on the keypad to clear and start again.
To enter the * or # keys in a telephone number (which may be needed
for calling card access or phone unlocking), press the DAY key on the
keypad followed by the desired key.
For example, 1234 <DAY> # 5678 enters 1234#5678, whereas if
<DAY> was not used, the # would terminate the key entry. (Applicable
to firmware version 4.45 and above)
To enter a pause or delay within a phone number, press the NIGHT key
on the keypad followed the pause in seconds. For example, 1234
<NIGHT> 35678 will insert a pause of 3 seconds during dialling
between the numbers 1234 and 5678. (Applicable to firmware version
4.45 and above)
Phone settings 1 and 2 only may be programmed to dial to Central
Monitoring Stations. Other phone types may also be assigned to the
first two phone settings if not used for Monitoring Stations. When this is
selected the Voice menu says:
Press 1 for Monitoring Station Code
2 for Monitoring Station Type
3 to Change Phone Number
4 for Voice Station Option
Monitoring Station Code (4,1,4,1)
The voice menu will say the current Account Number for the customer
e.g.
1234
Enter new number and # key
Enter the new 3 or 4 digit account number and #, or just # to leave the
number unchanged.
Monitoring Station Type (4,1,4,2)
This menu sets the Communication Format. The voice menu will say the
current type (i.e., the Communication format) e.g.
13
Enter new number and # key
Comfort Installation Manual
120