Installation manual

Press 1 for Description,
2 for Action Key
Press 1 for Description. Up to 4 words can be entered from the wordlist
(Table 1), as in the Zone Descriptions. The currently programmed
words are announced, followed by
Enter Word Number and # key
Enter each word (0 to 254) followed by the # key. If there are less than
4 words, enter 255# as the terminator. The voice menu repeats the
words entered. In the example enter words 6# (bedroom), 34# (light) ,
255# (terminator).
Press 2 for Action Key after the Description has been entered. Action
Key refers to the keys 0 to 9 and * which determine what action is to
be taken when the key is pressed. In this example, 1 is assigned to ON
and 0 to OFF. The voice menu says
Select Control Action Key. Press 0 to 9
Press 1. The Voice Menu says
No Action
as the Action Key has not been programmed.
Enter up to 3 word numbers from the wordlist (table 1) followed by the
# key in the usual way. If less than 3 words are entered, enter 255# as
a terminator. In the example, enter 230# for the word "ON". Enter
255# as the next word (terminator). The voice menu announces the
words entered , i.e. "ON" in this case. Next the system asks for the
Response, i.e.
Control Response 0, Enter Response Number and # Key
The Control Response is performed when the action key is pressed. This
Response does the actual work for the menu. For this example, turn on
X10 code A1, enter Response 33#.
There are a maximum of 11 actions keys 0 to * to be programmed in
this way. Program Action Key 0 for OFF (word number 229) and Control
Response 34.
Repeat for Control Key 2 - "Garage Gate". The table below gives the
settings for the example
Comfort Installation Manual
112