Installation manual

If Siren Delay is on for an Alarm Type, the Siren will be activated only
after the Siren Delay. The Siren Delay setting in minutes (0 to 255) is
in the Siren Delay location 51. The value entered for Siren delay has an
variance of -1 minute, i.e. entering a value of 2 minutes means the
siren delay is actually 1 to 2 minutes. If the Siren Delay is OFF for an
Alarm Type, the siren will be activated immediately without any delay.
The Siren Delay time is common to all Alarm Types which have Siren
delay enabled.
(( For UL installations, Siren Delay should be left off.
Trouble Arm (2,7)
Trouble Arm OFF,
Press 1 for ON, 0 for OFF
This setting determines if the user is allowed to arm the security system
when this alarm type is active. This only applies to alarm types which
have Trouble state, e.g. Zone trouble, Phone Trouble, Power Failure,
Low Battery, Home Tamper etc.. Selecting 1 (for ON) allows the system
to be armed when this alarm type is active, and selecting 0 will prevent
arming. If the Alarm Type is not a Trouble Alarm, this setting is ignored
Alarm State (2,8)
Alarm State, 1
Enter new number & # key
This setting assigns an alarm state to the alarm. The Alarm states are
Idle (0) , for non-alarm conditions like New Message, Arm, Disarm, Dial
Test etc, Trouble (1) for all system trouble conditions, Alert (2) for
Alerts triggered by Alert and Perimeter zones and Entry Alert, Alarm (3)
for full alarm conditions.
Control (3)
Press 1 for Control Menu
2 for Holiday
3 for Time Program
4 for Vacation Program
5 for Security Mode Response
6 for Response
Control Menu (3,1)
The Home Control Menu is a 2 level menu. The first level consists of
Control Keys 0 to 9 and *. This is for selecting the appliance to control,
or the group of appliances, for example, “Press 1 for Lights”. In this
example 1 is the Control Key, which is pressed to select Lights.
Comfort Installation Manual
109