Installation manual

Enter Dial setting 1 to 8
Enter 1 to 8 to select a Phone Index. The current setting (1 or 0) may
be changed by pressing 1 for ON or 0 for OFF to turn on or off the
setting for the phone index. If the setting for the phone index in ON,
activation of the selected alarm type will trigger a dialout to the phone
index.
This menu assigns dial settings to the Alarm Type. The assignment of
phone types and numbers to the dial settings is done in Change Phone
Numbers menu (Engineer menu 4,1).
Dial Delay (2,1,2)
Dial Delay OFF
Press 1 for ON, 0 for OFF
If dial delay is on for an Alarm Type, the system will start to dial out
only after the dial delay time. The Dial Delay setting is seconds (0 to
255) in the Dial Delay Location 161. The value entered for Dial delay
has a variance of -1 second, i.e. a value entered of 10 seconds means
an actual delay of 9 to 10 seconds. If the Dial Delay is off for an Alarm
Type, the system will dial out immediately when the alarm is activated.
The Dial Delay time is common to all Alarm types that have Dial Delay
enabled. If the system is already dialing out due to another activation,
Dial delay will not be applied for the new activation.
(( For UL installations, Dial Delay should be left off.
Alarm Report Code (2,1,3)
Alarm Report Code (digit 1), (digit 2),
Enter new number and # key
This is the 2 digit Report Code which is sent to the Central Monitoring
Station when this alarm type is activated. Report Codes for Contact ID
are preprogrammed. If it is required to change the default report codes,
enter the first digit of the new report code followed by # or just # to
leave the first digit unchanged. The range allowed is 0 to 15. Numbers
10 to 15 represent a hexadecimal code of A to F respectively. When the
first digit is entered, the voice menu says the value entered, and the
value of the 2nd report code digit e.g.
Report Code 2,.. zero
Enter new number and # key
Enter the 2nd digit of the report code and #, also in the range 0 to 15.
If only 1 digit is required by the Communicator format, the second digit
is ignored by the system, and is not sent. If the second digit of the
report code digit is set to 0, Comfort will automatically put in the zone
Comfort Installation Manual
106