Operating instructions

Loading the new ink film

1 Carefully remove the rubber rings from the new ink film.

Take care not to damage the ink film.

2 Lay the large roll in the grooves provided in the rear ink

film compartment.

3 Now take the small roll and lay it in the front ink film

compartment. Please make sure that the smaller roller is

inserted into the side identations.

4 Turn small roll forward to tension the ink film. Make sure

that the ink film is not creased.

5 Close the machine by swinging the operation panel

forward, until it snaps in.

6 Insert the yellow sheet with the printed side upwards and

press START/COPY.

A silver strip is fixed to the start of the ink film, so the

quality of the first few pages may be impaired.

Loading paper

Before you can copy documents, paper must be loaded in your

fax machine. Please use only the following paper format: stand-

ard A4, 210x297 mm. The fax machine works with normal pa-

per used for writing and copying and has been optimised for

smooth 80 g/m

paper. The smoother the paper surface the bet-

ter the print quality. If there is no paper in the fax machine the

red display lamp flashes and on the display appears:

OUT OF PAPER

1 Stick the paper support insertion in the openings provided

on the paper feed flap.

2 To prevent several sheets being drawn into the machine at

once, first fan out the paper to separate the sheets and then

straighten the stack on a flat surface before inserting it into

the paper feed.