Specifications

2 - 8 Getting to Know Your Repeater
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 1 D
term
Cordless DECT
5.4 Installing the Repeater
Be sure the wall material can hold the weight of the repeater. Never
install a repeater in damaged or decaying wall material.
1. Hold the repeater in its final location, and mark the center of the top
edge.
2. From the edge mark, measure down approximately 1-1/2 inches, and
mark th
e screw location.
3. At the screw location, use a 3/16ths drill bit to make a pilot hole
ap
proximately one inch deep.
4. Place the wall anchor into the pilot hole and tap it gently with a hammer
un
til the anchor is flush with the wall.
5. Insert the mounting screw into the anchor, leaving approximately 1/4
in
ch space between the screw head and the wall.
6. Put the wall mount slot on the back of the repeater over the screw head
an
d slide the repeater down into place.
Figure 2-5 Wall Mounting Repeater