User guide

Or, from your PC screen:

If alignment was initiated from the PC

Enter the numbers for all the patterns into the

Align Cartridges dialog box.

Click OK.

To clean the print nozzles

Load plain paper in the printer.

Either, at the BT MultiJet 3000:

Print a nozzle test page using the front control panel:

Press and hold the Scan button for 3 seconds.

The display will show CARTRIDGE ALIGN?

Press and release the Scan button again. The

display will show CARTRIDGE CLEAN?

Press the Start/Yes button. The nozzle

test page is printed.

Or, from your PC

Open the Control Program via Start, Settings,

Printers

, right click MJ3 printer icon and select MJ3

Control Program

Click on Cartridges tab

Select Clean Print Nozzles.

The nozzle test page is printed.

Compare the diagonal line above the printed bars to the

diagonal line below the printed bars. Look for a break in

the diagonal lines above the printed bars. A broken line

indicates clogged nozzles. If the bottom line still has

breaks, run the test up to two more times.

If the print quality is satisfactory after running the test

three times, the print nozzles are clean and you do not

need to wipe them.

If the print quality of both lines is not satisfactory after

running the test three times, wipe the print cartridge

nozzles as shown below.

Scan

Yes