User guide

Adding email to fax
1. Open the Welcome screen.
2. Click Browse Folders.
You first need to set up your email account and servers:
3. Click Set Up.
4. Click Email.
5. Click the Accounts tab.
6. Click Add.
7. Enter a name for your account, e.g. mymail.
8. Enter your Email address.
9. Enter your Reply address: normally the same as your
email address unless you want replies to go to
another address.
10.Click the Servers tab.
11. Under incoming mail, enter you POP3 account name
and password (the ones you use for receiving mail).
12.Click OK. The Email setup screen is shown.
13.Click the Servers tab.
14.Click Add.
Unimessage Pro can receive email messages from
mailboxes on POP3 email servers and send email
messages via SMTP email servers.
15.Enter the SMPT (outgoing mail) server name.
Click OK.
Note:
If your SMPT and your POP3 servers have the
same name, you can select Both to enter them
both at once.
16.Click Add.
Enter the POP3 server name. Click POP3 then OK.
17.When the Outgoing and Incoming servers are shown,
click OK.
You now need to configure your modem for email and fax.