Owner`s manual

BT Versatility

Owner's Manual

To change the System Programming Password

The default System Programming Password (1111) can be changed to any 4-digit number.

• From the Programming Extension, press the PROGRAMME Key

• Press the Scroll Down Key (Ô) until ‘System programming’ is displayed.

• Select ‘System programming’.

• Enter the System Programming Password and select ‘System’.

• Select ‘Change password’.

• Select ‘Change’ and enter the 4-digit number you require.

• Select ‘Confirm’.

Press the Hands-free Key to finish programming.

To configure unequipped Line interfaces

The system assumes that available Line interfaces have exchange lines connected to them. If a

line interface does not have an exchange line connected ensure correct system operation by

unequipping the line interface in system programming, as follows:

• From the Programming Extension, press the PROGRAMME Key

• Press the Scroll Down Key (Ô) until ‘System programming’ is displayed.

• Select ‘System programming’.

• Enter the System Programming Password and select ‘Lines’.

• Press the Scroll Down Key (Ô) until ‘Equipped Lines’ is displayed.

• Select ‘Equipped lines’.

• Select the lines you wish to equip or unequip. Equipped lines are denoted by a ♦.

Unequipped lines are denoted by a ◊.

Press the Hands-free Key to finish programming.

To configure disconnected Extensions

The system assumes that all available extension interfaces have devices connected to them. If an

extension interface does not have a device connected, ensure correct system operation by

disconnecting the extension interface in system programming, as follows

• From the Programming Extension, press the PROGRAMME Key

• Press the Scroll Down Key (Ô) until ‘System programming’ is displayed.

• Select ‘System programming’.

• Enter the System Programming Password and select ‘Extensions’.

• Press the Scroll Down Key (Ô) until ‘Extension disconnect’ is displayed.

• Select ‘Extension disconnect’.

• Select the Extensions you wish to connect or disconnect. Disconnected Extensions are

denoted by a ♦.

Press the Hands-free Key to finish programming.

Note: When a Featurephone is disconnected in programming, the Featurephone display will

show 'Disconnected'. However, when the handset is lifted a busy tone is heard and no options

will be displayed.