Owner`s manual

BT Versatility
Owner's Manual
108
The default is that all lines ring group 1 in both day and night modes.
If the switch is equipped with a PRI Access and some Backup Lines are equipped then Incoming
ringing is programmed as follows:
From the Programming extension, press the PROGRAMME key.
Press the Scroll Down key (Ô) until “System Programming” is displayed.
Select “System Programming”.
Enter the System Programming Password and select “Lines”.
Select “Incoming Ringing” option.
Select either 'PRI Access' or Line 31 - Line 34 or Access 1 - 2
Continue the programming as described above
In the case of PRI the B-channels cannot be separated so the full PRI is programmed to ring an
extension or group. It can also be programmed for Courtesy or Auto Attendant service.
Note: Lines 31 - 34 or Access 1 - 2 are the backup lines. Only those equipped are displayed.
No D-Channel backup is provided for the PRI Line.
Outgoing Restriction
Switch equipped with a PRI Access
If the switch is programmed with a PRI Access only this option is not presented on the Line
programming Menu.
If the switch is equipped with Lines as backup 'Outgoing restriction' is programmed as follows:
From the Programming extension, press the PROGRAMME key.
Press the Scroll Down key (Ô) until “System Programming” is displayed.
Select “System Programming”.
Enter the System Programming Password and select “Lines”.
Press the Scroll Down key (Ô) until “Outgoing Restriction” is displayed.
Select “Outgoing Restriction” option.
The menu updates to show only the back up lines equipped (Line 31 - Line 34 or Access 1- 2)
Select the required line
The extension menu is displayed.
Select the extensions to be restricted from selecting the line for outgoing calls.
In default no restriction applies.
Incoming calls only when PRI is programmed
When Incoming calls only is selected when the switch is equipped with a PRI Access the display
updates showing the B-Channels and backup lines and are programmed as follows:
From the Programming extension, press the PROGRAMME key.
Press the Scroll Down key (Ô) until “System Programming” is displayed.
Select “System Programming”.
Enter the System Programming Password and select “Lines”.
Press the Scroll Down key (Ô) until “Incoming Calls Only” is displayed.
Select “Incoming Calls Only” option.
The menu updates to show all B channels and the back up lines/Accesses
Select the required lines to be reserved for incoming calls only.
In default no lines are programmed.
Note: If 12 B-Channels are available and 8 lines are selected then a total of 4 B-Channels
are available to extensions to select for outgoing calls.
If a user selects a Line key of a line that is set as Incoming only, busy tone is returned and the
message 'Restricted' is shown on the display.