User guide

Set-up 

 If your computer is already connected to your Hub using an Ethernet cable,
unplug this cable.
 Place your computer close to the Hub for a good wireless signal.
 If you haven’t already, install your wireless adapter in your computer using
the adapter manufacturer’s instructions. If you’re using a laptop with built-in
wireless, turn wireless on by either using the wireless switch (if your computer
has one) or activating wireless from within your wireless software. Your wireless
adapter must be 802.11b or g compatible.
If you don’t have a wireless adapter or your computer isn’t wireless-enabled,
see page 47.
 Find your Hub’s preset wireless network name/SSID and Wi-Fi key (WPA2).
These are printed on your wireless settings card (found in your Hub’s box) and
also on the side of your Hub.
 Follow the instructions for your computer’s operating system below or, if
your wireless adapter has its own software, use this to set up your wireless
connection – its help function may be useful if you aren’t sure how to do this.
Your wireless settings card Wireless settings label (on side of Hub)
BTBusinessHub-XX
XXXXXXXXXX
XXXXXXXXXXXX
Wi-Fi Key: 1234567890
S/N: 123456789012
P/N: 4201-003004-000
FLX
SSID: BTBusinessHub-###
2701HGV - C
Learn about… Set-up Extra features Help