User guide

Extra features 
 click Save before you close the window. You may be asked to enter your password
– if you haven’t changed it, the default password is the same as the serial number
on the bottom of your Fibre Hub
Once you’ve set up your multiple Static IP addresses, you can use one of the
following methods to assign your LAN computers to your public Static IP addresses.

 If your Fibre Hub’s address is 217.37.237.78 and the subnet mask is
255.255.255.240, manually change the computer’s TCP/IP settings from
Obtain an IP address automatically to Use the following IP address.
 Enter the IP Address you wish to set the computer to (e.g. 217.37.237.65) and
the Subnet mask to 255.255.255.255.0, the Gateway to 217.37.237.78
and the DNS Server to 217.37.237.78.
 Renew the IP address of the computer as shown below. Your Fibre Hub
automatically detects the Static IP and removes the IP address from the public
Static IP DHCP pool.

 Keep the computer in DHCP mode.
 Open your web browser, type  (for your Fibre Hub Manager) in the
address bar and press Enter or your return key.
 Select Settings, then LAN, followed by NAT & Address Allocation.
 For the required device, select Public (select WAN IP Mapping) for Address
Assignment and Public Fixed: 217.37.237.73 for WAN IP Mapping.
 Click Save before you close the window. You may be asked to enter your
password – if you haven’t changed it, the default password is the same as the
serial number on the bottom of your Fibre Hub.

 Keep the computer in DHCP mode.
 Open your web browser, type  (for your Fibre Hub Manager) in the
address bar and press Enter or your return key.
Learn about… Extra features Help Your Fibre Hub