User's Manual

BTM-002 Bluetooth Headset
User Guide
Please follow the simple steps to operate the Bluetooth headset :
Battery Charging
1. Turn off the headset.
2. Connect the charger to the main power and plug the adaptor to the
charging socket of the headset.
3. During charging, the LED will turn red. When the battery is fully
charged, the LED will be off.
4. Disconnect the charger from the main power and the headset.
BT-200 Headset Overview
Remark : If the headset is not used for a long time or the battery is
drained, the indication of charging (red LED) will be displayed a few
seconds later
Charging Time
The headset is equipped with a built-in rechargeable battery. For the
first time of use, please charge the battery for 14 hours. Thereafter, the
battery charging time is normally within 3 hours. After the battery is
fully charged, press the multifunction button for 6~7 seconds to turn
on the headset. Please refer to the next page of “Turning on and off the
headset” for details
Talk and Standby Time
The fully charged battery can allow about 4 hours talk time and about
160 hourr standby time.
Battery Low
When the battery becomes low, the LED flashes red and the headset
emits “beep, beep” sound every 2 minutes. Please recharge the battery
as described above.
Turning on and off the headset
Turning on the headset
Press and hold the multifunction button for 6~7 seconds until 2 short
beeps are heard. The LED will flash blue.
Turning off the headset
Press and hold the multifunction button until the LED flashes from
blue to red. Then release the multifunction button immediately. The
headset will be off when the LED stop flashing.
Pairing the headset with a Bluetooth mobile phone
Before using the headset for the first time, the headset must be paired
up with a Bluetooth mobile phone.
1. Place the headset and the mobile phone within 1m apart where
they are easily viewable.
2. Ensure the headset is at standby mode.
3. Press and hold the VOL+ key until the LED flashes blue and red
alternatively.
4. Follow the manual of the mobile phone to activate your mobile
phone’s Bluetooth function.
5. Search from the mobile phone for the headset you are using.
6. Enter the password “1234” to the mobile phone. When the pairing
is complete, the headset LED will flash blue rapidly.
7. Return to the mobile phone’s main menu. A headset icon will be
shown on the screen for certain mobile phone models.
Remarks : If the pairing cannot be completed within 1 minute while
the pairing mode is activated, the headset will return to standby
mode. Please pair up the headset and the mobile phone again.
Using your headset
Answering a call
Wait for the headset to ring, then press the multifunction button to
accept the call or answer the call via your mobile phone in the normal
way.
Ending a call
Press the multifunction button to end your call or end the call via
mobile phone.
Dialling from your mobile phone
Simply make calls on your mobile phone in the normal way.
Voice Dialling from your headset
If the mobile is equipped with the voice dialling function, press the
multifunction button and when you hear a beep, say the voice tag.
Remarks : Please make sure to record voice tag into the mobile phone
first before using voice dialling function..
Last number redialling
Press the VOL- button for 3 seconds and release the button, you will
hear a beep. The last number will be redialled after you hear two beeps
again.
Remarks : The voice dialling and last number redialling functions
are only applicable to mobile phone with Bluetooth handsfree
profile. Functionality varies depending on the mobile phone model
you have. Please refer to your mobile phone user guide for
additional information.
Adjusting the volume
Press the VOL+ or VOL- repeatedly until the desired volume level is
reached.