User Manual

4
EN
USING THE MIC INPUT
Insert a standard 6.5mm connector of a wired microphone (not included) into the microphone input jack .
Use the mic volume knob to adjust the volume.
WARNING: It is recommended to turn the speaker's microphone echo knob to the left all the way. To prevent
any feedback or loud pops when connecting the microphone.
MOUNTING THE SPEAKER
The speaker can be mounted on any conventional stand mount with a maximum shaft diameter of 1.45".
Unscrew the butter󰊠y screw, insert the rod of the stand into the shaft hole and tighten until secure.
Make sure that the stand is capable of supporting up to 6.8kg.
Speci󰈛cations
Input voltage 5V󰐆 1A via supplied USB charging lead
Built-in battery Lithium 3.7V󰐆 2000mAh
Play time at 100% volume with LEDs on 2 hours
Play time at 80% volume with LEDs o󰊞 4 hours
Signal-to-noise ratio >70dB
Frequency response 80Hz - 18kHz
BT frequency 2402-2480MHz
Bluetooth version 5.0
Max. RF transmission power 0.998dBm
Dimensions 235 x 210 x 385mm
Weight 2.4kg
Correct disposal of the product
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return your used device, please use the return and collection
systems or contact the retailer where the product was purchased. They can take this product for environmental safe
recycling.