User manual
BSD Racing - RAMASOON BS916T - Notice en Français & English Manual - Beez2B - Version 1.00 - Juin 2016
Page 4
Notice traduite en français et mise en page pour Beez2B par Model Consult - www.model-consult.com
SAFETY PRECAUTIONS
• This radio controlled racing car is not a toy!
• This high-performance R/C model is recommended for ages 14 and older.
• First-time builders should seek the advice of experienced modellers before commencing assembly.
• Take enough safety precautions prior to operating this model.
You are responsible for this model's assembly and safe operation!
SAFETY NOTES
Please, read the instructions carefully before starting the assembly or use.
• 1. Please, assemble ans install this car without children's reach. As it includes small ans sharp parts.
• 2. Do not run the car on public streets or highways. As it might cause serious accidents, personal injuries and property
damages, etc.
• 3. During the middle of racing and after operation, the engine and exhaust will become hot. Therefore, do not touch them
before cooling down.
• 4. Please, make sure everyone is using dierent frequencies while racing the car in the same area.
2.4 GHZ RADIO INSTRUCTIONS
Special symbols
Please, pay attention to the following symbols, and read them carefully .
Danger :
If the operator doesn't operate according to the instructions, it may lead to serious injuries, even
mortal danger.
Warning :
If the operator doesn't operate according to the instructions, it may lead to serious injuries, even
mortal danger.
Attention :
If the operator doesn't operate according to the instructions, it may lead to serious injuries, event
mortal danger, but generally, it will not cause serious injuries to the operator.
Safety guidelines
• Don't drive the vehicle at night, bad weather such as rainy or thundering days. It will interfere the transmitter signal. Thereby it
will cause out of control and unexpected accident.
• Before you drive, please make sure the movement of servo correspond with the direction of controls ont the transmitter. If
inconsistent, please, adjust before drive.
• You need to turn the throttle channel (CH2) and inching switch to the lowest before use. Then, switch on the transmitter
power, and nally connect the receiver.
• The sequence of shutdown is to turn o the receiver power rst, and then the transmitter power.
• If the above operations are reversed, it might lead to out of control and cause accident.
Battery charging
If your transmitter, receiver, use a NiCd, NiMH rechargeable battery, you have to check it before use. If lack of electricity, it
could cause inadequate control or out of control, resulting in accident. So please charge it immediatly when the battery
power is low.
ENGLISH