Manual

BSA Optics, Inc. • 3911 SW 47th Avenue • Suite 914 • Fort Lauderdale, Florida 33314 • Tel: [phone] • Fax: [phone]
e-mail: [e-mail] • website: www.bsaoptics.com
2. ATTACHING THE CORRECT MOUNT TO THE DEVICE
WARNING: BE CERTAIN THAT YOUR GUN IS UNLOADED AND POINTING IN A SAFE DIRECTION.
Simply slide the appropriate rail onto your gun and tighten it into place utilizing the two rail attaching screws and the larger of
the two supplied hex head wrenches. Note the “weaver-style” rail utilizes a lock screw to prevent its slippage under recoil. This
lock screw should be fit into the groove found on most “weaver-style” mounts. To prevent the loosening of any of these screws
under recoil, the use of a thread-locking compound is recommended.
3. ACTIVATING THE LASER
WARNING: DO NOT LOOK DIRECTLY INTO THE LASER BEAM OUTPUT
APERTURE DURING OPERATION. PERMANENT EYE DAMAGE MAY RESULT.
3. A. Installing the batteries
Your new laser is powered by three long-life lithium batteries. They may be found in the small plastic bag with the wrenches
and momentary pressure switch. To install the batteries, locate the pressure switch access panel and rotate it down into the
body of the laser. Then, push down on the front of the battery cap and slide it back, off of the body of the laser. Next, insert
the batteries into the battery holder with the “+” side up. Slide the battery cap back into place.
3.B. Main on-off switch
With this switch, you may turn the laser on or off.
3.C. Momentary Pressure Switch
This switch allows you to turn the unit on or off with pressure. The pressure switch access panel at the rear of the device must
first be opened. Open this panel by applying pressure on its top and rotating it down. Push the pin connector on the end of
the pressure switch firmly into the port. The pressure pad has an adhesive on its end and may be attached to a convenient
location on your gun.
3.D. Emission indicator
Your laser is equipped with an emission indicator at the end that the laser
projects from. The indicator glows red when the laser is functioning. If you do not wish to use the indicator, it may be removed
by simply pulling it free from the body.
4. ALIGNING THE LASER WITH THE PATH OF THE BULLET
WARNING: DO NOT LOOK DIRECTLY INTO THE LASER BEAM OUTPUT
APERTURE DURING OPERATION. PERMANENT EYE DAMAGE MAY RESULT.
WARNING: EXERCISE SAFE GUN HANDLING. SHOOT ONLY AT AN APPROVED RANGE OR SUITABLE
LOCATION. USE EYE AND EAR PROTECTION AS
NECESSARY.
4A. Activate the laser by either the pressure switch or the main switch.
4B. Carefully fire three shots.
4C.
Observe the bullet’s strike on the target. To move the point of impact, there are two screw ports at the front of the device.
The one marked “E” will move the point of impact up and down (Elevation) and the one marked “W” will move the point of
impact left and right (Windage).
(Continued on next page)