Manual

BSA Optics, Inc. • 3911 SW 47th Avenue • Suite 914 • Fort Lauderdale, Florida 33314 • Tel: [phone] • Fax: [phone]
e-mail: [e-mail] • website: www.bsaoptics.com
LASER SIGHT INSTRUCTIONS
ATTENTION
THIS LASER TARGET DESIGNATOR IS A POWERFUL DEVICE THAT REQUIRES SPECIAL ATTENTION FOR
ITS USE. READ THE FOLLOWING INSTRUCTIONS AND SAFETY PRECAUTIONS CAREFULLY BEFORE USE.
CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
AVOID DIRECT EYE EXPOSURE TO THE LASER BEAM.
KEEP OUT OF THE REACH OF CHILDREN.
Congratulations on your purchase of this laser-aiming device. It is a high quality device incorporating advanced laser optics and
microelectronics. With proper use and care, it should provide you with many years of reliable service.
SPECIFICATIONS
650 nm index-guided laser diode
Class 3a (<5mW) output power
Three LR44 lithium batteries
Advanced composite body
Momentary pressure switch, 8" in length
Mounting rail for 3/8" grooved receiver (airguns and
.22 rifles)
Mounting rail for .852" “weaver-style” bases
Large hex head wrench
Small hex head wrench
Visible range: Indoor Lighting Conditions: 100 yards
Outdoors at night: 300 yards
Range of windage and elevation adjustment: more
than 60 inches at 100 yards.
1. SELECTING THE CORRECT RAIL MOUNT
FOR YOUR GUN
The laser attaches to either a 3/8" grooved receiver,
found on most, .22 rifles and air guns, or to a .852"
“weaver-style” base as installed on most centerfire
pistols and rifles.
The laser is shipped with the mounting rails for a
“weaver-style” mount already installed. If you need
to attach this device to a 3/8" grooved receiver, you
will need to loosen the two rail screws and remove
the 3/8" dovetail mounting rail and replace it with
the “weaver-style” set.
(Continued on next page)
ACCESSS
PANEL
(Roll back to expose
MPS connection)
MOMENTARY PRESSURE SWITCH (MPS)
WARNING LABEL
BATTERY
CAP
MAIN
ON/OFF
SWITCH
EMISSION
INDICATOR
LASER
BEAM
AVOID
EXPOSURE
LABEL
WARNING
LABEL
CERTIFICATION
IDENTIFICATION
LABEL
(on bottom)
DANGER
LASER RADIATION
AVOID DIRECT EYE EXPOSER
DIODE LASER
MAX OUTPUT<5mW
WAVE LENGTH 300-680MM
CLASS MIA LASER PRODUCT
AVOID EXPOSURE
LASER LIGHT IS EMITTED
FROM THIS APERTURE
AVOID EXPOSURE LABEL
SIDE VIEW
FRONT VIEW
ELEVATION
ADJUSTMENT
WINDAGE
ADJUSTMENT
Manufactured: March 1999. Manufactured by Op. Electronics
Co. ltd. Shing Ping Rd., Chung Li, Taiwan. This is to certify
that this product is in conformity with performance standards
for laser products under 21CFR 1040.
RAIL
SCREW
MOUNTING RAIL FOR
“WEAVER STYLE”
BASES
MOUNTING RAIL FOR
.22 AND AIR GUN
GROOVED RECEIVERS
FIG. 1